New guy here looking for some help. My PowerSpec Ultra prints have started leaning to the left. Its a steady slow lean. I have tightened the belt (from tight to very tight) and that has not helped. The pulleys are the type without set screws so that shouldn't be an issue. I use a dial indicator to level the bed and have it dead nuts level. I have done a factory reset incase some internal settings have gotten messed up. I have tried powerprint, flashprint and also bought S3D. Same thing with all of them. Its not making any weird noises or doing anything that seems abnormal. Correct me if I am wrong but the only things left to try would be to replace the cable to that stepper motor and if that does not help replace the stepper motor itself. Anybody have any ideas or am I on the right track? I am pretty new to 3D printing and this is my first printer. Been getting some beautiful prints from it until this issue popped up.