Close



Results 1 to 4 of 4

Thread: printing error

  1. #1

    printing error

    so ive been printing on an ender 3 since decemberish and things have been smooth, recently added a CL Touch to it and now my prints dont print properly. is there something i can do to fix this or am i doing something wrong? the picture is cheps bed leveling print
    Attached Images Attached Images

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    It appears your nozzle is too high an needs to be lowered.

    I use Z-Offset to lower the nozzle to get about .2mm above the bed. currently my Z-Offset is set at -0.50
    I have had this setting from 1mm to -1mm to allow the nozzle to be in the print area
    Last edited by Roberts_Clif; 03-06-2022 at 04:14 PM.

  3. #3
    I’ve tried setting my offset but when I get to 0 the nozzle is touching the bed, I’m probably doing something wrong

  4. #4
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •