Close



Results 1 to 3 of 3
  1. #1
    Technologist
    Join Date
    Nov 2014
    Posts
    138

    Can Prusa Super Switch!!

    Can prusa super switch be connect to my Rambo board that came with my makerfarm 12 that only supports 2 extruder, to connect 4 extruder and can that probably be used for other 3d printing boards? Because if I could and I do have the motors how hard will be to convert the mk2 extruder mount to my makerfarm, not that hard. https://www.youtube.com/watch?v=9rTeyPZDn_0


  2. #2
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    at 1:30 into the video Prusa talks about how they handle the 4 extruder problem. He did say they were using RAMPS boards (which only have 2 extruders). He holds up a proto-type board (with 'blue wires' which in this case are red) and says that board converts the 2 extruder system into a 4 extruder system.

  3. #3
    Technologist
    Join Date
    Nov 2014
    Posts
    138
    Quote Originally Posted by Roxy View Post
    at 1:30 into the video Prusa talks about how they handle the 4 extruder problem. He did say they were using RAMPS boards (which only have 2 extruders). He holds up a proto-type board (with 'blue wires' which in this case are red) and says that board converts the 2 extruder system into a 4 extruder system.
    Figure much thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •