Results 1 to 2 of 2
Thread: filament curl up in the j-head
-
09-18-2016, 04:35 AM #1
- Join Date
- Sep 2016
- Posts
- 3
filament curl up in the j-head
hi!
I have a problem. When i print, the filament curl up in the j-head or the feed tub.
I dont know witch factor cursing this behavior. i see three diferent factor that can course this. But i dont know witch one. I tried different way to solve this problem but none of them did solve the problem.
the temperature: i tried different temperature but dont seems to mater
feeding speed: i tried to change the speed with some success but then the filament get choppy.
hotend hight: i tried higher the printer head. but the filament get choppy.
any ides what can course this behavior or witch factor that could course this.
here is a link how its looks. http://www.ehel.se/3d_jam.jpg
thanks for help.
-
09-22-2016, 06:16 PM #2
You have a space between the end of the ptfe tube and the heatbreak. make sure that the ptfe hose is pushed into the j head as far as it can go.
Extruder not feeding during print,...
Yesterday, 01:59 AM in Tips, Tricks and Tech Help