Close



Results 1 to 4 of 4
  1. #1

    RUMBA / MARLIN / Proximity Sensor

    Hi Everyone

    Can anyone assist me please?

    I want to setup a proximity sensor on a RUMBA board with the MARLIN firmware.

    1. How to wire it?
    2. Changes in Firmware?


    Rgs
    Scalci

  2. #2
    What kind of sensor exactly are you attempting to use?

  3. #3
    Apologies for the delay...

    It is a Inductive type proximity switch
    Last edited by scalci; 10-09-2016 at 12:43 AM. Reason: add photo

  4. #4
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    Go look through the Configuration.h file. In the RCBugFix branch (which is the one you should be using) the stuff to setup the probe is all together. The only magic for the Inductive probes is you won't need a servo to be defined. And typically, the Inductive probes have a postive (not negative) Z_PROBE_OFFSET_FROM_EXTRUDER.


    There should be good comments to guide you on how you want the probe setup in the Configuration.h file.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •