Does the software for the USB version exists ?

[redox]

Hi all,

I received an USB version of the kit last month, so it seems to be what was supposed to be the "final version", but I still have not finished to build it, and I was wondering if the software to pilot it exists somewhere ?
I have read most of the thread speaking about software, but I am not sure if what can be found on the github is compatible with this version of the hardware...

Regards,
Seb

[NathanGrayston]

Hey Redox,


Here is the web page that links to software dl, instructions, and the peachy forum:

http://www.peachyprinter.com/#!get-started/en0zq

As long as you haven't upgraded the firmware on the board, that link should just work.

Good luck with the build!