Close



Results 1 to 1 of 1
  1. #1

    [low-cost RESIN] SLA Printer

    Hello,guys!
    I am new here and hadn't had much time to look for a similar thread.

    We're building a 3D SLA Printer based on an existing one,but using a different resin and projector.

    We are now testing the new resin on the old printer first.

    Old printer uses : * Resin : MakerJuice Labs G+
    * Projector : ACER p5307wb

    New printer has to use : * Resin : Hegardt H-61
    * Projector : ACER P6500 (more powerful)

    Current testing status : * Resing: Hegardt H-61
    * (old projector) : ACER p5307wb

    The issue is that the resin H-61 doesn't cure .
    We increased the exposure time,but it doesn't seem to cure any UV with our parameters.
    We loaded a test cube (10x10x2 [mm] ),the ETA was 30 minutes,but nothing solidified .

    (The tank that we're using is a "sample tank" which was successfully tested with MakerJuice G+ resin and the ACER p5307wb projector )

    What solutions could you have for this new resin ?
    It is very similar to glue,so dens.
    What parameters should we change or something like this ?

    I am looking forward to reading your comments upon this.

    Thank you for your attention !


    L.E.: I have just uploaded some photos of our 'devices' :


    Last edited by robert13; 04-06-2016 at 05:39 AM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •