Close



Results 1 to 3 of 3
  1. #1

    Updating the board with a Atmega2560

    Hi,

    I got an old mightyboard that was a bit broken, repaired it and replaced the Atmega1280 cpu with a larger Atmega2560 as some sailfish features are suposedly only available for this one.
    Now i did not found any instruction how to firmware on properly.
    I got a boot loader installed and I can upload Atmega2560firmwares form replicator G but non is specifyed to be the right one for the CTC printer.
    So which one should I take? Also what stuff do I need to put into the EEPROM, as its a new chip its obviously empty.

    Any advice would be greatly appreciated.

  2. #2
    Technician
    Join Date
    Dec 2015
    Posts
    80
    Not sure, but I am guessing that once you download all the latest firmwares from jetty using repg, you install the Makerbot Replicator 1 with ATmega 2560.

  3. #3
    Ok, and what about the eeprom is ther some guidefor this update procedure?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •