Raft not printing properly

[Print Plastic]

I am trying to print a Yoda tealight and it will not print properly
as you can see by the Photo it only prints on 1/3 the diameter of the part.
at layer 10 it starts to print the back but it is air printing.
what do i need to do to get the raft to be under the whole part.
below are 3 pics.

Thanks in advance.

raft.JPGlayer 10.JPGraft-settings.JPG

[Roberto]

Howdy
look like you didn't place it on the table properly. It's tilted up from back side.
This is why it doesn't show first layers in preview.