Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3

Thread: setup help

  1. 12-02-2015, 01:39 PM #1
    Nasty1
    Nasty1 is offline
    Student
    Join Date
    Nov 2015
    Location
    Enfield, CT. USA
    Posts
    2

    setup help

    I have a prusa i3, it came with an auto bed level sensor, this is a green box with a red light. Where does this plug into the board ?
    Reply With Quote Reply With Quote
  2. 12-02-2015, 03:40 PM #2
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    It depends upon how you have your printer configured. In Configuration.h you will be looking for Z_MIN_PIN. It might be on that pin unless you have dual Z Min endstops defined.
    Reply With Quote Reply With Quote
  3. 12-02-2015, 03:53 PM #3
    Nasty1
    Nasty1 is offline
    Student
    Join Date
    Nov 2015
    Location
    Enfield, CT. USA
    Posts
    2
    Nothing setup yet, it's all new to me, trying to install pronterface now, getting no were, can't find a install file
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules