Close



Results 1 to 2 of 2
  1. #1
    Student
    Join Date
    Feb 2015
    Location
    Coon Rapids, MN
    Posts
    15

    Lite6 Extruder? Anyone used it yet?

    Going away from my hexagon hot end and looking for a new alternative. I would like to try the Lite6 as I only print in ABS and PLA at the moment. I see Colin has them on the site for $31.50. Anyone have any remarks on it?

    Matt

  2. #2
    It's just OK. Print quality looks the same as a clone in my opinion. My heat sink came in bent. Not sure if it's from the bubble envelope it shipped in or from the factory. The fan spins really fast and is not balanced; it could cause ripples on sides. It also does not come with a guard and the sharp blades are exposed. I replaced it with a slower 4 blade fan and guard. The injected molded red fan shroud does not fit tight around the heat sink and spins. You get what you pay for.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •