Einscan-s free scan calibration

[propologist]

So what is the process to calibrate in free scan mode?

[Nerv]

Calibrate your scanner with the turntable and then it is finished. No further calibration required for the scanner for free scan mode.

[propologist]

OK THanks.

[propologist]

I find that after scanning with the turn table and then going to free scan and then back to turn table I have to re calibrate.

[Nerv]

Yes, the key word here is that you don't have to recalibrate again for freescan mode.

As you have found, if you want to go back to the turntable you have to recalibrate so the software knows where the rotational axis is.

[propologist]

Ok, So we can move the turn table out a little and re calibrate to auto scan some thing a little larger?