Close



Results 1 to 2 of 2
  1. #1

    Question At print start the extruder nozel moves off plate ?

    Hello,
    We have a CTC dual extruder printer that has a problem.
    When any print is started the extruder normally moves across front of the bed-plate to get filament flowing,
    then goes to proper location to start print.
    But now it goes Past the edge of plate, hits side, then goes to proper location.
    Everything else is working properly.
    Is there a setting or adjustment to control how far the extruder moves during that clean-out pass ?
    Thanks of any help or suggestions,
    Last edited by EagleSeven; 07-23-2015 at 10:22 AM.

  2. #2
    I found that this problem was caused by one version of Makerbot software.
    Fixed now, using different version.
    Last edited by EagleSeven; 07-23-2015 at 10:23 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •