Results 1 to 3 of 3
-
04-15-2015, 05:09 PM #1
- Join Date
- Apr 2015
- Posts
- 2
Question: Prints raft, but not part
My makerbot 5th gen has worked fine for a couple of months, but suddenly it won't print parts. Was able to clear jam, now filament will load and unload fine - extrudes out fine, but when i go to print a part, it WILL print the raft, but then suddenly stops and 'air prints' when it gets to the part - it stops extruding filament.
I'm wondering if others have had this problem or have suggestions.
thanks
-
04-16-2015, 07:49 AM #2
-
04-21-2015, 02:35 PM #3
- Join Date
- Apr 2015
- Posts
- 2
haven't tried that - good suggestion...
Print not sticking to base plate?
Yesterday, 01:26 PM in General 3D Printing Discussion