BIZER III 3D Printer

[MiniMadRyan]

I was inferring all 3D technologies originated with another product.

Kinda like car engines. All manufacturers make their own however they all have pistons, rods, and crankshafts..... Even the Hybrids. They are not so different.

There has never been a copyright filing by Form1 to CTC.

Unless you are a lawyer, I wouldn't slander companies to which we have no actual information.

I wasn't slandering you or CTC purposely. You stated that CTC collaborated with Form1, yet a verified Form1 employee says they have never had anything to do with CTC. Pretty cut and dry if you ask me...

[CTC-USA]

I wasn't slandering you or CTC purposely. You stated that CTC collaborated with Form1, yet a verified Form1 employee says they have never had anything to do with CTC. Pretty cut and dry if you ask me...

If that was true, then Form1 would have an clear cut case wouldn't they?

There is more to the story I assure you.

[MiniMadRyan]

If that was true, then Form1 would have an clear cut case wouldn't they?

There is more to the story I assure you.

True enough, I respect that you may know more than I do regarding the situation, but understand that from my perspective (and probably that of others too) would conclude the same sentiment as I did.

[CTC-USA]

True enough, I respect that you may know more than I do regarding the situation, but understand that from my perspective (and probably that of others too) would conclude the same sentiment as I did.

Yes others are free to form their own opinion.

We never went to kickstarter, nor complained of others using our innovations.

I do not believe Form1 is a patented tech, therefore others can use the design.

Although, I am not the owner of CTC and I am only sharing my opinion.

[MiniMadRyan]

You've got a very good point there.
It doesn't look like you could. Unless the sides come off easily.

The likelihood of that happening is probably low, but least from these pictures it appears it would be hard to do. I wonder what they are using to control the touch panel

[CTC-USA]

The likelihood of that happening is probably low, but least from these pictures it appears it would be hard to do. I wonder what they are using to control the touch panel

We are using our own electronic PCB for the motherboard. Not a clone from another maker. Its available in ENG and JAP

[CTC-USA]

In case you guys were wondering about Bizer 3 build size:

Building Size : 225 * 145 * 150mm

Bizer 3 Info