Search:

Well, It took an hour after I got home from work, But I think I solved it. My original config was to do the abl at the extended 155 servo number. Also turn off power to servo 300 Ms. After...

Odd with the jitter. I use the exact same model servo on my makerfarm 10 and it works fine after I set the power delay to 300 in the ramps configuration. for some reason, the Pegasus 12 has an...

it was fairly cheap. I also found that it "over runs" a couple degrees. For example, my straight up and down is 155 in the servo support in Marlin configuration H. Using prionterface, I...

Thanks Everyone. These instructions saved me quite a bit of time. All is good now, but I did come across one other little issue and I think I figured out how to solve it. After a coupe good...

OK, First let me apologize if this is like basic 101 stuff. I am having a brain fart. so, here is my issue..i think.

With my Makerfarm pegasus 12, i have set up auto bed leveling and...

Hello,
I have the Makerfarm 12" Pegasus. I started wth a 10 prusa Makerfarm and loved it so much, I wanted something bigger. As for assembly, It's very easy as long as you follow each step...

Hi All,

Curious, after my printer checks the 9 points of the bed using the Auto Bed leveling, There is a big "clump" of pla that has oozed out do to the heat of the hot end. normally it will...

I am not sure if this will help you much, But I have a Pegasus 12 and I have Auto levelling with my single extruder and server controlled microswitch working perfectly. Here is the Configuration h...

OK, I have auto bed leveling currently set up. I will check to see how that performs with 50 microns. My offset is pretty accurate, but i think I put in .1mm...i'll check it out.

thanks...

Cool, Thanks. So right now, i print (in my simplify3d settings) at .15 mm layer height. In order to try printing at 50 microns, I should change that layer height to 0.05?

Hello,

Equipment:
Makerfarm 10" prusa I3
Makerfarm 12" Pegasus E3d6V
Simplify3D (recent version as of this post date)

My Question. I hear a lot of people trying to print at 50 microns and...

First thing I did once done was to print all the spare parts if needing replacement...idler, DD mounts...ets.

Cool Cable track. I used the TechFlex Flexo F6 for mine. It allows me to double up wires that are too long like the right hand side z motor.
https://www.techflex.com/prod_f6n.asp

The self...

Just finished mine a couple weeks ago. The fire blanket i had laying around from a forge shop I work at. You can get them online. it lays flat on the aluminum heat shield.
I found only two...

I just finished my Pegasus 12 and I am partly done configuring it. I added an auto level servo...just fyi. I too use Simplify 3D. I'm still playing with certain settings, but after doing a...