Search:

Thank you very much for all your Feedback!

I have been printing different models now and simply increasing the minimum layer-time seems to work. So the problem realy was my impatience :-)
...

Thank you for your advice :)

The slurry worked fine on all previous prints. With thinner slurry, i got lifting edged from time to time. Since i made it a thicker mixture, i hat no failures like...

Hi joop,
thanks for your reply.

I was using ABS-Slush on the plate to make the print stick better. Since i did not clean up the surrounding area after a previous print, i had bubbles of ABS on...

Hello.
i have aproblem with some printer-settings using ABS.

Every time some pieces of the print are getting narrower, they start to be printed "not solid". Since i have no better description of...

Update on my Parameters:

Without changing my mechanical configuration, i am now able to print with 50mm/s solid, after i dialed down the Acceleration-Seting in the Printer to 500.
The...

Since milcent postet also in the other thread, we might want to shift our conversation to that thread and close the topic here.

Link:...

So, after a short vacation, i finally got back to printing. At first i have to say, that my problems are SOLVED!

I bought some Kapton-Tape and it led to better adhesion, but not to a point, where...

So, i have tried about 15 prints with gluesticks.
The success-rate is slightly higher than the glass surface alone, but stuill dissapointing.

However the first tries with ABS-SLush seem to be...

Right now i am trying out Gluesticks + ABS.

As you said, gluesticks are a very easy solution and indeed seem to improve bed adhesion with ABS. However i am not to a point, where i would be...

Hope your board arrives soon :-)

I have run into some problems with ABS, too.
So my settings might be used with caution.

I will update the settings, if i find a solution to my current problem....

Hello guys,
i have some problems with my Printer.

I have been printing PLA sucessfully on a glas surface with a slightly heated bed.
After that, i tried printing ABS, but it did not want to...

So, i have had a few days to play around with the settings.

I had to buy Buildtak Platform tape, otherwise the print would not stick.

Using NuNus ABS Filament, the following settings work for...

PROBLEM SOLVED!!!

I pried of the pinheader for D8 and D9 on the Arduino and discovered, that the metal-contact of D8 inside the pinheader had one half of the contact in D8 and one in D9, so it...

I have connected them the way you described it.

I even disconnected the cables and connected them to another 12V supply to see, if the labels were correct and if there might be a shortcut...

Thank you joop.
I may try it, too.

I have discovered another "problem" and was wandering, if that behavior is correct.

My method was printing a gcode file with just one line of code and then...

No, i had to reflash the firmware.
I did not change it because of printing problems, but because something in the menu did not work.

So i am currently running the one thats also on the HK-Website...

Hello!
Thank you for your reply!

I got it working by just trying around.
The Problem was related to insufficient filament flow. When i increased the Extruder-Temperature, the print got much...

Hi there,
i got my first printer a few days ago.
Had to fiddle around some time to get it working, but now it starts to print.

My problem however is, that from about 3mm above the bed on, the...