Search:

Hey there,

I am trying to get my Prusa I3V setup with the Itty Bitty Double Flex extruder and I'm struggling with nozzle height.

I was hoping to get some remedial instruction to ensure that I...

Daniel,

May not be relevant, but I was having a similar issue with extruding while I was trying to calibrate e steps.

Using pronterface I would extract 100 mm, but it would slow down and stop...

Hey, I have two possibly silly questions.

First, as I am struggling to get my double flex extruder working well I am looking through the marlin configs. In the config you need to specify the...

Quick question about the height adjustment process.

In the instructions on Clough42's website, it says to run G28 (autohome), then G29, and then move the nozzle to the center of the bed and adjust...

Here is what I got when running from a cold start:

PID Autotune start bias: 127 d: 127 min: 234.53 max: 241.67
bias: 115 d: 115 min: 236.25 max: 245.00
bias: 132 d: 122 min: 233.75 max:...

Good morning all,

I just switched over to a new hot end, the Prometheus V2, and I am having some issues with tuning the PID of the thermistor.

I am having large swings I the hot end temp @240...

That is awesome! Great work, especially love the carpet sliders.

Bill

Hey all,

I've gotten my Prusa I3v up an running, belts tightened and e-steps roughly calculated, now I'm trying to get some good references on how to keep tuning. There is so much information...