Close



Dig deeper, search our News website




Search:

Type: Posts; User: DanB

Search: Search took 0.00 seconds.

  1. Thread: Filament jamming

    by DanB
    Replies
    3
    Views
    2,992

    I just verified that my hot end readings are...

    I just verified that my hot end readings are accurate. I have a multimeter with a thermometer and they basically read the same values sticking the thermistor in the slot and the multimeter in the...
  2. Thread: Filament jamming

    by DanB
    Replies
    3
    Views
    2,992

    Filament jamming

    Hi guys,

    I know this issue has been covered far and wide on different forums but I am having a hell of a time just getting my i3v to extrude on pronterface, let alone actually make something! With...
  3. Replies
    4
    Views
    2,383

    Constant jamming problems

    Hi guys,

    I know this issue has been covered far and wide on different forums but I am having a hell of a time just getting my i3v to extrude on pronterface, let alone actually make something! ...
  4. Replies
    5
    Views
    3,002

    Thanks guys, I got it figured out.

    Thanks guys, I got it figured out.
  5. Replies
    5
    Views
    3,002

    Heat bed relay question

    Hi guys,

    I hooked up the heat bed relay by moving the 11 amp power supply directly to the relay and followed the instructions per the guide. There are now no wires going to the 11 amp power...
  6. Thread: Heat bed relay

    by DanB
    Replies
    2
    Views
    2,532

    Heat bed relay

    Hi guys, I have an 8" prusa i3v and I'm trying to install a heat bed relay. Does anyone know which wires from my antec power supply to plug into the relay? There were no instructions on this that I...
  7. Replies
    1
    Views
    6,396

    Kisslicer settings for the prusa i3v

    Title pretty much sums up what I'm looking for. I need to print abs. I had no luck with slic3r, it kept crashing. If anybody has the settings or can point me in the right direction I'd greatly...
  8. Replies
    5
    Views
    3,674

    Thanks, I tried it and it worked. I thought...

    Thanks, I tried it and it worked. I thought about doing this earlier but was afraid I'd damage something.
  9. Replies
    5
    Views
    3,674

    On initial testing x axis problems

    I'm finishing up an i3v and on initial testing the x axis goes in the wrong direction. My understanding is that this is a firmware issue of some kind? How do I fix this?
  10. Thread: Need some help

    by DanB
    Replies
    5
    Views
    3,644

    Thanks guys, I got it figured out now.

    Thanks guys, I got it figured out now.
  11. Thread: Need some help

    by DanB
    Replies
    5
    Views
    3,644

    Need some help

    Finishing up on my I3v and I tried to wire in the power supply using an antec vp450 and nothing happened when I turned it on? Could it be possible that I crossed some wires after I snipped the tips...
Results 1 to 11 of 11