If it is a moisture problem rather than putting it in the oven, you might try heating your 3d printer heat bed to 50 to 70C & placing the roll on the heatbed for a half hour on each side to pull the...
Type: Posts; User: PyramidDave
If it is a moisture problem rather than putting it in the oven, you might try heating your 3d printer heat bed to 50 to 70C & placing the roll on the heatbed for a half hour on each side to pull the...
I am just printing PETG at 230 with no heatbed on painters tape & elmer's gluestick on Mirror from Lowes.
Maybe next time I order from there, I will buy some of those. I would especially like to run the X-motor wires through there. I am currently running my X-motor wires across the top. They would not...
That one I did not put on thingiverse. Maybe I should. I had not decided whether it was a good idea or not. It is 6 pieces slid over the V-slot to shield the limit switch wires. Probably could...
They should all be in the makerfarm group on thingiverse located here. http://www.thingiverse.com/groups/makerfarm-i3v/things or here is a link to all of my designs on thingiverse:...
I have changed a lot of the wooden parts on my i3v 10" printer with plastic. I am really happy with the X-carriage printed in PETG & the wire cage around my electronics. I ran a 14 hour print last...