Search:

Hi not long had my ctc brought is as my clone makerbot board stopped working


so brought a ctc basically the same upgraded the feeder and replaced the throats to ones that don't use ptfe tubes....

I have uploaded marlin firmware to support a heated bed, soldered the 4.7k in place. I use my ulti controller to heat the bed but the red led on the board will not light/flash witch means I can turn...

Hi I found on thingiverse http://www.thingiverse.com/thing:36837! I really like the idea of a bigger version of the ultimaker 1 I have now. does anyone no anythink about the ultimaker xl and links...

Thanks for all the replys.

I have tried at 195c and got this result.

http://i61.photobucket.com/albums/h58/saxo123/20140823_230226_zpsaiea187m.jpg????


few videos of a print I have just...

Thanks for the reply's. I did another print yesterday while glue stick holding down the blue tape. I think a lot better result although was a different print. I will try lower the temp to 195/185....

Hi well im using a ultimaker 1 and using cura's quickprint profiles "normal quality print" . temp is 220c using pla

Im trying to print this http://www.thingiverse.com/thing:53690

pics below
...

Hi, Sorry I ment 220c temp :) Im still using basic profiles so not really played about with any settings?

Hello im new to 3d printing. small objects print fine but slowly getting into the bigger prints and now finding out I have a warping problem :( I am using blue tape but the blue tape is peeling away...