Found a temporary fix (could be permanent, it works well). Removing these lines, then hand-setting the nozzle to the right height before each print:
G28 Z0 ;move Z to min endstops
G1 Z15.0...
Type: Posts; User: eligri
Found a temporary fix (could be permanent, it works well). Removing these lines, then hand-setting the nozzle to the right height before each print:
G28 Z0 ;move Z to min endstops
G1 Z15.0...
Check PM :)
(Not my model, so sent file-link there)
Nah, this print worked before ^^
Slicer is at 0.06mm layer height
;Layer count: 211
;LAYER:0
M107
G0 F9000 X86.52 Y87.76 Z0.30
;TYPE:SKIRT
G1 F1200 X88.74 Y86.66 E0.15431
G1 X88.94 Y86.45 E0.17195
G1 X89.34 Y86.25 E0.19979
G1 X89.74 Y85.86 E0.23511
G1...
Hmm, cant find anything similar to that. Made in Cura. Anything I can search for in the document?
M140 S70.000000
M109 T0 S220.000000
T0
M190 S70.000000
;Sliced at: Sun 10-09-2017 20:09:51
;Basic settings: Layer height: 0.1 Walls: 1 Fill: 35
;Print time: #P_TIME#
;Filament used: #F_AMNT#m...
Hi!
For some reason my Anet A8 has started printing 1cm too high. It happened after one print finished, when I tried to start the next one. I have adjusted the heatbed, lowered the nozzle,...