Close



Dig deeper, search our News website




Search:

Type: Posts; User: Trakyan

Search: Search took 0.00 seconds.

  1. Replies
    18
    Views
    10,703

    The issue with the bed is odd, they don't usually...

    The issue with the bed is odd, they don't usually run too hot, too cold is fairly common. Does it stay 5-9 degrees hotter than it should be during the whole print or just initially? It could still be...
  2. Replies
    18
    Views
    10,703

    I was explaining to CA who asked why you would...

    I was explaining to CA who asked why you would slow it down at all. I find it odd the bed and hotend run on the same pid. If you're willing to do some firmware digging you could probably seperate the...
  3. Replies
    18
    Views
    10,703

    CA, the point of slowing down the heating on the...

    CA, the point of slowing down the heating on the heated bed (your extruder also does this) is to avoid overshoot. If you don't slow it down as it approaches the temperature (and like wise slowly ramp...
Results 1 to 3 of 3