3 Attachment(s)
Anyone care to take a look at a pic of sagging and give input?
The stringing you see is just remnants of the support I was using
Maker Select 3D
PLA 1.75mm
.4mm nozzle
.20mm layer height
.8mm shell thickness
1.2mm Bottom/top thickness
10% fill density
75mm/sec print speed
200C Print temp
70C bed temp
I've taken a dial indicator to the bed and in the middle it bows down about .003" vs. the edges but I doubt that's an issue.
Attachment 10296Attachment 10297Attachment 10298
Thanks for any input guys.
Davae