-
Hmm that's a good idea
Filament was set to 1.77 and it's 1.75 diameter so I changed that.
Print speed is 50 and travel speed is 150mm. These are all default setting I never changed anything. So i'll try what you said and i'll knock the speed down to 100 and see if that makes a difference.
-
Just my luck, both print heads are jammed. I tried to stick a sewing needle in there with no luck. Any other ideas? I took the fan off and can't visually see anything.
-
Printing much better now. but still have a rough finish on the top. Wonder if there is a setting for the finishing layer and what I should change it to?