Wanhao i3 wont stop when my probe is activated (ramps1.4) PLEASE HELP

I'm switching over my wanhao i3 that had a z probe with stock board and marlin to ramps with repetier firmware. It doesnt stop when my zprobe is activated. I use M119 and it shows that my zprobe and my z min(which is my probe in the min pins) is H when not activated and L when activated and i set the firmare to be normally closed. Please help

If you have Repetier firmware.... You don't have Marlin. If you had Marlin firmware, I could help you.

i was using repetier but i figured it out on marlin, thanks though.