problem with quality print

hi
I Set Cura setting wiith these numbers
but why the quality in too bad
NEED HELP
Attachment 6131Attachment 6132Attachment 6133

I'm not very experienced.... But that looks like a lot of variance on your x or y axis. Are the belts nice and tight?

i use slic3, the only obvious difference in the settings I could spot is the "100 % fill" mine is set to 50% and makes a lovely little honey combe pattern. (But I don't think that is your problem)

cheers
Docker

Take a look at this
http://reprap.org/wiki/Print_Trouble...ictorial_Guide
Could be Z axis wobble also

Try to put a fan close, try to see if your X & Y belts are loose, try to print another item at the same time (to increase the time between layers).

If your belts are tight, you might have bad or worn bearings, especially on the Z axis. This is easier to check on a kit printer, as you can decouple the Z axis motors and check for free movement of the axis (it should be obvious from the sound if you've got bad bearings).