AIO Robotics zeus

hello! i was hoping some one could give me a hand with a AIO Zeus printer. first off i bought this printer used and it worked fine all day, got a couple a prints out of it no problem. the next morning i boot it up and it constantly reboots. i knew going in that this printer was a bit risky buy but it was extremely cheap, the 12 rolls of unopened filament cost more than what i bought it for. any who, i have no clue what to do to try and resolve this problem. all i have to go off of is a "exynos4-reboot: Notifier called" i cant find any documentation for trouble shooting. if i could bypass the AIO operating system and use something else that would be ok too.

thank you for listening to my rant :)

if it matters this is a AIO306D