Quote:
[COLOR=rgba(90, 90, 90, 0.901961)]After installing the 0.8mm filament, we’ve been able to push this up to [/COLOR][COLOR=rgba(90, 90, 90, 0.901961)]20mm^3/s[/COLOR][COLOR=rgba(90, 90, 90, 0.901961)] and potentially higher by printing at 0.5mm layer height at 50mm/s. On a practical level, this means that we can now print a low resolution version of this cute octopus model in 27 minutes instead of the 3 hours estimated under our previous settings. Printing with substantially higher layer height required that we recalibrate the bed to a somewhat farther distance, but was otherwise very straightforward. The filament used here is Colorfabb Leaf Green PLA/PHA, which we’ve had very good luck with.[/COLOR]
It took me maybe 30 minutes to write my message, but I was also replying to earlier comments and observations and asked several questions instead of just one. (Then I went to sleep and when I came back there was a reply already.) Reading your answer took about 3 minutes and it directly answered a few of my questions and at least pointed out what I'll find when I actually do a more detailed search with Google or whatnot. Your answer will benefit not just me but potentially hundreds (if not more) people reading the forum or using search engines.