Can Prusa Super Switch!!

Can prusa super switch be connect to my Rambo board that came with my makerfarm 12 that only supports 2 extruder, to connect 4 extruder and can that probably be used for other 3d printing boards? Because if I could and I do have the motors how hard will be to convert the mk2 extruder mount to my makerfarm, not that hard. https://www.youtube.com/watch?v=9rTeyPZDn_0

https://www.youtube.com/watch?v=9rTeyPZDn_0

at 1:30 into the video Prusa talks about how they handle the 4 extruder problem. He did say they were using RAMPS boards (which only have 2 extruders). He holds up a proto-type board (with 'blue wires' which in this case are red) and says that board converts the 2 extruder system into a 4 extruder system.

Quote:

---

Originally Posted by Roxy

at 1:30 into the video Prusa talks about how they handle the 4 extruder problem. He did say they were using RAMPS boards (which only have 2 extruders). He holds up a proto-type board (with 'blue wires' which in this case are red) and says that board converts the 2 extruder system into a 4 extruder system.

---

Figure much thanks