-
Prusa i3 building
hey i yust bought a prusa i3 from 3dprintersonlinestore it comed well pakaged and was made of very nice acrylic parts i built up the mechanical part in 5 hours then wired yaaay now im in the part of calibration :D:D:D:D but ... what software do you recomend for calibrating?
-
There's a good description of the calibration process over at the reprap wiki:
http://reprap.org/wiki/Calibration
The calibration process doesn't require any software above and beyond what you normally use for 3D printing.
-
Welcome! The Prusa i3 is an amazing 3dp & will serve you well