Printable View
Hi !
I would like to get an advice. I wanted to make with Creatr HS + Simplify3D a nice sculpture print, but
I faced this kind of holes :confused:.
Attachment 7156
I wonder if this is because I should put 3 layers instead of 3 or whether it is the FormFutura filament.
Any idea or experience return is welcome ! :cool:
What layer height?
What print speed?
What material?
What temperature?
What infill pattern/percentage?
What amount of solid vertical, horizontal shells?
In general, I would recommend slower print speed and more shells in horizontal and on top.
Thanks !Quote:
Originally Posted by Davo
I don't remember exactly but quite low speed compared to usual and very high quality (0.100 or 0.080). PLA from Form Futura. Temperature was 205 degrees C, I think.
Infill quite low. 10 % around.
Shells : 2 for everything. But I'm printing something else right now with 3 layers for everyting and it does that for certain curves :/ , so it's something else.
I wonder if material or temperature (had other issues with higher temp). Form Futura roll says temp should be 210 to 220.
No one experienced that ?