Oh hell no!
I wouldn't even wish that kinda torture on my worst of enemy's!!
Printable View
Hey!! Don't laugh! Here is a 60 year old sub model I am restoring after it was damaged by UPS.
[IMG]http://i58.photobucket.com/albums/g2...psdvuygeig.jpg[/IMG]
Tried them both. The first is supposed to be able to print with minimal support but haven't tried it that way yet.
The second one I am trying with custom supports also but found the bottom isn't flat. Not the biggest deal but it leaves hollow spots on the bottom and causes the edges to lift. I am going to pull that one into Fusion and spiff up the bottom some.
Here is the current left blower only (with flanges) http://www.thingiverse.com/thing:1716089
I printed without any supports in MG Raptor PLA at 230/60
http://i.imgur.com/RbDqwpq.jpg
http://i.imgur.com/SO0w6S8.jpg
I use this one for Dual PLA prints. http://www.thingiverse.com/thing:1542849 Printed in MG ABS at 230/110. No supports.
http://i.imgur.com/l2Pgz31.jpg
http://i.imgur.com/zJzS6Ie.jpg
My favorite Spudgers for removing supports...
https://www.aliexpress.com/item/Best...618321470.html