2 Attachment(s)
Warped layers on the edge of print (not the base)
Hi,
I am getting some problems with layer warping on the edge of my print (see the attached photos). I am printing with ABS at 240 degrees.
There were no problems with bed adhesion i.e. the print did not lift from the bed. The printer is a custom reprap-based printer and is surrounded by walls to isolate it from air currents
Also, you can see a shift in the printing pattern in the horisontal plane about one third of the way up the structure. What could cause this?
Any ideas of what I could do to avoid this?
cheers, Daniel
Attachment 10449Attachment 10450