Raft not printing properly

I am trying to print a Yoda tealight and it will not print properly
as you can see by the Photo it only prints on 1/3 the diameter of the part.
at layer 10 it starts to print the back but it is air printing.
what do i need to do to get the raft to be under the whole part.
below are 3 pics.

Thanks in advance.

Attachment 8690Attachment 8691Attachment 8692

Howdy
look like you didn't place it on the table properly. It's tilted up from back side.
This is why it doesn't show first layers in preview.