Printing Profile for Simplify 3D

Printable View

03-31-2015, 06:18 PM
BLKKROW

Printing Profile for Simplify 3D

Anyone have one handy? After being sick for a few weeks and dealing with a calculus exam. I have the bed level and ready to print just struggling with the settings on Simplify 3D so I wanted to reach out to see if anyone had one handy.

#1 Any firmware configure files?
#2 Any Printing Profiles?

I have a 12" Prusa Iv3
03-31-2015, 07:20 PM
dunginhawk

what specifically are you struggling with?
I have been running the 12" for a couple weeks with pretty good results... im using S3d with some basic settings. nothing fancy.
03-31-2015, 10:58 PM
Chadd

3 Attachment(s)

I have a few S3D profiles for both ABS and PLA but I have auto bed leveling so you would need to change some of the beginning Gcode. Some of these profiles have ABL in the start Gcode some don't. Also setup for 3mm filament with hex head and .4mm nozzle. You will probably need to play with these to get it where you want but you can use them for a starting point anyway.

You will need to change the file name from .txt to .fff because the forum wouldn't let me upload .fff files.

Thanks,
Chadd

Quote:

Originally Posted by BLKKROW

Anyone have one handy? After being sick for a few weeks and dealing with a calculus exam. I have the bed level and ready to print just struggling with the settings on Simplify 3D so I wanted to reach out to see if anyone had one handy.

#1 Any firmware configure files?
#2 Any Printing Profiles?

I have a 12" Prusa Iv3

Attachment 5491 Attachment 5492 Attachment 5493
03-31-2015, 11:35 PM
BLKKROW

Quote:

Originally Posted by Chadd

I have a few S3D profiles for both ABS and PLA but I have auto bed leveling so you would need to change some of the beginning Gcode. Some of these profiles have ABL in the start Gcode some don't. Also setup for 3mm filament with hex head and .4mm nozzle. You will probably need to play with these to get it where you want but you can use them for a starting point anyway.

You will need to change the file name from .txt to .fff because the forum wouldn't let me upload .fff files.

Thanks,
Chadd

Attachment 5491 Attachment 5492 Attachment 5493

I have not looked at your settings as of right now as I am heading to bed.

But the printer is at the home position (all the end stops triggered). Then after the heatbed and hotend reach temperature, it starts to print in that same corner and not in the middle of the build plate.

Any ideas?