Printable View
I have my itty bitty dual extruder working
when i print this with my left extruder with white ABS its not filling it properly
and large spacers are shown
When i print it with my right extruder and black Abs it prints fine
using exactly the same settings
I dont want to mess with my esteps as it affects both extruders..
thoughts?
http://3dprintboard.com/attachment.p...tid=4613&stc=1
something is slipping if you can put a few rubber bands around the top and see if the added grip helps if so your just slipping on the filament
extruder 1 and 2 each have there own Esteps and just because the uses the same parts means nothing
on my rig E1 = 892.4 steps E = 872.3 but i'm using 2 of the stock extruders right now converted to bowden with dual hexagon
i have printed most of the itty bitty dual even have a hardware kit just waiting on steppers and free time
another thing that can do this is height make sure both hotends are dead Even
Where in marlin is the estep for the other extruder
do i just add it after the first extruder?
also in the lcd control i dont see a 2nd e step setting
As of at least the September 2014 Marlin source code that I use, there is no support in Marlin for more than one extruder steps per unit value. One can add as many additional parameters as one wants to the DEFAULT_AXIS_STEPS_PER_UNIT array, but they won't do anything. The code in configurationStore.cpp will only read in the first four values, and the variables holding the run-time per-axis values for steps per unit, feed rate, and acceleration are only sized to hold four values.