Measuring RAMPS Board Stepper Motor Voltage

Using the attached image, could someone draw where you would place the multimeter probes to measure the voltage of a stepper motor on a RAMPS board?

Attachment 803

Thanks,
Old Man Emu

Do you mean this? This link shows where you measure vref for setting current limit on a pololu.

Otherwise I'd refer to the pololu wiring diagram here. It looks like you can measure the voltage supplied to an individual stepper across the VMOT and GND pins.

Got it. Thanks.
Glad you put in the first link because I found this:

Set VREF to 0.32V on a genuine Pololu or 1.28V on a Stepstick. That gives a current of 0.8A

I have the stepstick and would have used the 0.32V if I hadn't read this.

Old Man Emu