Slicer/Marlin - How to get the extruder away from the print when a print finishes
I'm sure there has to be a simple way to make this happen.
Whenever I finish a print, the extruder is left sitting over (on) the finished print. Since no filament is retracted, and the head is still on the print, I get a gob of filament there. If I'm watching (which is often), immediately when the print finishes I use R-H's manual controls to home X, raise Z and retract some filament.
But this has to be a common problem for everyone. Is there some setting in Slicer or Marlin that will move the print head out of the way when a print finishes?
Thanks, Ira