Taulman Bridge - great results
Just wanted to tell you guys, after lots of trying to get basic nylon 6 and then taulman 618 nylon to print properly with little joy, I got a reel of Taulan Bridge and played with it at the weekend.
Absolutely great results.
245 degrees, 50 degree bed, and I just stuck some UHU glue stick glue on the top of kapton tape.
Printing out at full 90mm/s/150mm/s
Works a treat. Parts are indestructible.
They are quite bendy at 10/30% infill, but you can try with all yer might and they just spring back again.
If you need something with the strength of nylon, I'd definately recommend giving it a try.
stu