Using PETG with X-Plus white side of build surface
Hello,
After destroying 2 bed surfaces by printing PETG on the white side with a bed temp of 80 degrees C (could not get the model off-ripped the white sticker), I dialed the bed temp back to 30 degrees C and I was able to get a fairly simple release.
Does anyone else use the white side of the build surface for PETG?
If so, what are your settings?
Are there any issues with printing PETG with a near ambient bed temp?
I tried using the smooth side - but even up to 90 degrees C with or without glue, but I could not get the model to stick.