You guys are totally the best!!! I tried 220 and it did not work, changed to 200 and there is very very little webbing, ill try 180 next
Its a different part, but this one had the exact same issue and now there are little threads, before it was thick spider webs like on the other part.
Attachment 3467
Geoff, I do have a question, since lower seems better, sounds like I should just keep lowering till the webs are gone and stick with that, are there any advantages to higher temp? stronger etc?
Since there are no odd noises at 200 maybe I can get this last bit of webbing out by changing to 180c
Currently I am using this and the webs are almost gone.
extruderTemp: 200
retractDistance: 2.5
retractRate: 35