S3d platform purge line

For the short time I used RepG the one thing I liked and I think helped out tremendously is the start. RepG prints a full line across the front edge of the platform then proceeds to the object. With S3d right now the problem that I have is roughly the first 5/6 seconds do not stick to the bed and fail but if i don't cancel the print the filament grabs and proceeds without issue.
Any knowledge or script somewhere I can grab to make it replicate the RepG start ?

I'm using glass bed with abs juice

Better off just doing a skirt around the object.

i have just purchased s3d, and i still have the purge line, but i also have a skirt set, and works very very well

Ah very good call with the skirt don't know why I didn't think about that thanks !

The latest version of S3D does that line across the front edge by default. However, I also use a skirt, and if I'm printing with both extruders I use either an ooze shield or a prime pillar, depending on how large the print is.