Hi, I can't seem to get my E3D to get a firmware update to work, but I keep getting the following error:
avrdude: stk500_getsync(): not in sync: resp=0x89
Any idea what this is? What could be causing it?
Printable View
Hi, I can't seem to get my E3D to get a firmware update to work, but I keep getting the following error:
avrdude: stk500_getsync(): not in sync: resp=0x89
Any idea what this is? What could be causing it?
Have you tried starting from scratch? That's what I'd suggest. Can't think of any other solution.
Jan
Which Solidoodle do you have? if you have SD2/3 you can use this guide at least.
Also dont forget to edit the max allowed temp as E3D will run a much higher temp with the 12W heater, thus allowing for way faster extrusion speeds (mind the fumes though)
I have SD 3. Which guide are you referring to Mysli?
I'm having a similar issue. Mysli, could you please explain what you mean by "this guide"?