I am at a loss to figure this out. I use ABL, verified that the Z offset is correct. Nothing has changed in S3D settings, same roll of filament as my last successful print.
Attachment 9103
Printable View
I am at a loss to figure this out. I use ABL, verified that the Z offset is correct. Nothing has changed in S3D settings, same roll of filament as my last successful print.
Attachment 9103
It does look like you are a little bit too far off of the bed. And you may need more hair spray in the middle.
In spite of being sure of my measurements, I took your advice and added .1 to my Z offset, and now it's printing perfectly. Thank you.Quote:
Originally Posted by Roxy