strange bubbling issue occuring after 7th or so layer
Hi Guys.
This has only just started happening recently. But on some of my prints after a few layers, certain parts of the prints start bubbling. On this one, it always starts to happen on the same place on layer 9 then just keeps doing that.<br>
Ive even rotated the print thinking it was a bed levelling issue but still happens in the same place same time.<br>
Is there a rule to the dimensions of an actual design you should avoid?
https://s32.postimg.org/4of0cgr7p/image_2199.jpg
https://s32.postimg.org/ijdauxlmt/image_2200.jpg