I started printing wire saver for Dremel 3D printer and found out that the plastic piece that go on top of the extruders already have a small cylinder where the wires go into but ithat cylinder won't keep the wires from bending. Any suggestions?
Printable View
I started printing wire saver for Dremel 3D printer and found out that the plastic piece that go on top of the extruders already have a small cylinder where the wires go into but ithat cylinder won't keep the wires from bending. Any suggestions?
Sorry, what part do you mean?
Can you post a picture of it?
http://www.thingiverse.com/thing:1549265
The parts were made for Powerspec 3D Pro and 3D Ultra printers that have a flat black plastic piece on top of the extruders and where filaments go through the holes. They were supposed to keep the wires from bending as the extruders go back and forth. The Flashforge Creator Pro at the program for mentally handicapped people has a plastic piece on top of the extruders with a short cylinder supposed to hold the wires but it didn't work.
Ahh, OK, I used this design http://www.thingiverse.com/thing:616895